RDZ01 LFS Manual
Picture 5-2 Work parameter
Open delay is the time of punching hole. Close delay is set to be zero. The laser through mode must be enabled.
Through power is the laser power of punching hole.
6 Software of LFS
Parameters for LFS controller are set through the USB. Please install the USB drivers correctly. If the
driver is installed correctly, the device named EPLC driver is listed in the machine device.
After installing the USB driver for LFS, the parameter configuration software should be installed. The
software named RD_Tracer in the CD. The interface of the software is shown as picture 5-3.
Click “Open USB” which on the right side of the interface, if there is no error feedback, that means the LFS and
the PC communication successfully. Click on the "Read" to get the parameters of the LFS controller. Click
"Write" to write parameters to LFS memory.
RuiDa Technology
1B-1,Building 5,Tian'an Nanyou Industry Area,
Dengliang Road,Nanshan District, Shenzhen
Telephone:86- 0755-26066687
E-Mail: support@rd-acs.com 18
Web: www.rd-acs.com
FAX: 86-0755-26982287
    "